Assembly - Glomex DISCOVERY S460S User And Installation Manual

6.

ASSEMBLY

S
DANGER
While installing the antenna, wear the appropriate
safety equipment for the job to be carried out.
Operations to be carried out outside the vehicle.
1. First of all, make sure you have chosen a cor-
rect position to install the antenna (see section
5: "Installation").
2. Remove the antenna from the packaging box.
3. Carefully clean the 4 mounting plates on the
antenna and the vehicle roof with alcohol and
let evaporate before applying the sealant.
Fig. 4
4. Drill a hole by means of an electric drill and a
12 mm drill tip on the vehicle roof for the pas-
sage of the 5 m coaxial cable; if necessary, use
a fairlead code RA140 (not supplied).
5. Apply sealant type SIKAFLEX®212-FC or simi-
lar onto the plates.
6. Place the antenna in the appropriate position
on the vehicle middle line, respecting the instal-
lation direction indicated in Fig. 5 and apply a
good pressure on the radome sides to make the
plates correctly adhere to the mounting surface.
www.glomexmobile.com
Fig. 5
7. OPTIONAL OPERATION: drill the plates with
an 8 mm drill tip and fasten the antenna to the
roof with the appropriate screws.
Fig. 6
S
WARNING
Fastening with sealant is necessary and sufficient
for the correct use of the equipment.
Fastening with the screws (not included) of the
radome on the roof is optional.
Fastening with screws only does not guarantee a
perfect coupling of the radome to the roof.
GLOMEX declines any liability for an incorrect cou-
pling of the radome to the vehicle roof.
11
DISCOVERY S460S
EXPLORER S460M