Initial System Configuration; Configuring The System - Iridium 9801 Installation Manual

5 I

Initial System Configuration

Configuring the
System
Figure 5
Iridium Openport Terminal
There are two levels of diagnostic information available, basic and
administrator. Configuring the system and full diagnostics can only be
done by the System Administrator and requires a login password.
To access the ISU Web Pages:
1 .
Connect a PC to the data port on the BDE
2 .
Open the web browser and in the web browser address window, type:
http://192.168.0.1.
Note: The default IP address is assigned to the ISU at the factory. The IP
address can be changed if there are multiple ISU's at a single site. If this has
been done then type in the new IP address. To reset the IP address back to
the default (192.168.0.1), press the network reset button on the BDE .
I 1
3 .
Select "Login" for administrator level diagnostics. Type in the user
name and password specified by Iridium. Call your Service Provider if
login fails.
I 5 Initial System Configuration
power
status
signal
GPS
data voice 1 voice 2
Reset button
®
voice 3
5.1