Installing The Bde - Iridium 9801 Installation Manual

Installing the
BDE
Figure 4 I 4
After a suitable location has been chosen, mount the BDE:
1 .
Layout the locations for the mounting screws,  total. The BDE is
mounted with the connector edge facing down. Use the included
template as a guide for drilling the mounting holes.
2 .
Drill and tap holes for M4 flange style mounting screws
Note: Alternative screws or screw / washer combination may be used.
The flange must fit into a 4.5 mm (.18 in.) hole.
4 .
Hold and screw the BDE against the wall.
5 .
Remove the SIM cover (retain)
6 .
Switch the ON/OFF switch in to the OFF position
7 .
Remove installation cover from bottom left hand corner of BDE
(retain cover and screw)
8 .
Connect internal cables:
a . Fit power feed (either AC or DC) to power connector on BDE, use
strain relief provided within BDE. The power LED should light
Amber.
b . Fit cable from ADE to BDE, use strain relief provided within BDE
9 .
After checking that all the connections are securely made and have
strain relief, replace and fasten the installation cover.
Installation
cover
Iridium Openport Terminal
POWER
STATUS
SIGNAL
GPS
SIM
voice 2
voice 1
data
on / off
SIM cover
I 4 Installation
Mounting
hole
Power LED
voice 3
4.9