Clevo P170SM Service Manual page 46

Disassembly
Processor Installation Procedure
Figure 18
Processor
1. Insert the CPU
Installation
FORCE IT!), and turn the release latch
2. Remove the sticker
a. Insert the CPU. 3. Insert the heat sink unit
b. Turn the release latch to-
4. Tighten the CPU heat sink screws in the order
wards the lock symbol.
18d).
c. Remove the sticker from
5. Replace the CPU fan, component bay cover and tighten the screws
the heat sink unit and in-
sert the heat sink.
a.
d. Tighten the screws.
b.

A. CPU
D. Heat Sink
• 4 S crews
2 - 22 Removing and Installing the Processor
, pay careful attention to the pin alignment
A
towards the lock symbol
B
(Figure 18c) from the heat sink unit (if it is a new unit).
C
as indicated in
D
c.
C
A
d.
2
B
4
(Figure 18a), it will fit only one way (DO NOT
(Figure
Figure 18c.
, &
, (the order as indicated on the label and
1 2 3 4
(page 2 -
D
Note:
Tighten the screws in the order 1-2-
3-4 as indicated on the label.
1
3
18b).
Figure
20).