Advertisement
The Receivers
Probe Inserts
Plastic Backstrip
Comfort Contacts
Be careful not to over-tighten the probes. Over-tightening can cause damage to
the probes and receiver case.
If you wish to attach the receiver to a collar other than the one provided by your Pet Stop dealer, you
must create two holes for the receiver inserts, washers, and probes. Be sure the holes are correctly
sized to fit properly. After doing so, follow the above steps to attach the receiver to the collar.
Adjusting the Receiver Collar on your Pet.
It is important that the probes sufficiently make contact with the dog's skin. One finger should fit
between the dog's neck and a probe. Your Pet Stop dealer will demonstrate proper collar snugness.
Be sure to check the collar every few days for proper snugness. Your dog will not feel a correction if
the collar is too loose, and may escape from the yard. Always remove the receiver collar at the end
of the day when your pet is inside.
The receiver collar may
need adjustment due to
changes in your pet's coat,
weight and age.
10
Attaching The Receiver
Attaching the UltraElite or UltraMax receiver to
your collar is easy!
1.
Place the collar holes over the receiver
inserts. Be sure the receiver case is on the
out side of the collar.
2.
Install the plastic washers with the flat
side toward the probes.
3.
Attach the probes by screwing them
snugly (preferably by hand) into the
receiver inserts.
Battery Replacement
To replace the battery, remove the battery cover
with any flat-head screwdriver or a coin. Remove
the old battery and discard it. Insert the new
battery with the positive (+) end UP toward the
battery cover. If you are uncertain which side of
the battery is the positive side, look closely at the
flat side of the battery. You will see a plus (+) mark
indicating the positive end.
Battery Maintenance
Battery maintenance is convenient and easy.
Your Pet Stop dealer can offer you a battery
subscription plan which will make the timing of
battery replacement hassle-free. With this plan, you
will receive a battery in the mail when it is time to
replace it. Ask your Pet Stop dealer for details.
RoomWizard® – Wireless
Your Pet Stop RoomWizard can be set up in your home as either as wireless or wired system,
depending on the needs of you and your pet.
Pet Stop RoomWizard - Wireless Operation
Place the RoomWizard unit in the location you want your pet to avoid. For example, if you do not
want your pet to jump on the sofa, place the unit under the sofa. The RoomWizard can also be
permanently mounted on a wall using the key hole slot on the bottom of the transmitter case.
RoomWizard
Under normal operation, the RoomWizard will display the signal field strength number (such as
"10") and will make no sounds. This indicates the RoomWizard is operating normally. You can make
adjustments to the signal field range to achieve the correction zone you desire. Pressing the upper
button ("+") will increase the signal field to a maximum of 32. Pressing the lower button ("-") will
decrease the signal field to a minimum of 1.
To turn on the RoomWizard unit:
1.
Plug the AC adapter into an AC electrical outlet.
2.
Plug the other end of the AC adapter into the LEFT connector on the RoomWizard marked
"Power" as shown in photo below.
3.
The Range display should be lit to indicate the RoomWizard is on. If the range display is not lit,
press the top Range Adjustment button to turn the unit on.
4.
Adjust the signal field range by pushing the upper button (+) to increase the range and the
lower button (–) to decrease the range.
5.
Test the signal field range by using the receiver collar and listening for the beeps.
Remember:
Always remove your pet's
Pet Stop receiver collar
before making any
adjustments to the
signal field range.
RoomWizard -
Wireless Operation
AC adapter
7
Advertisement
