Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Maxford 40” EP Gee Bee Y Scale ARF V2
Summary of Contents for Maxford 40” EP Gee Bee Y Scale ARF V2
-
Page 1: Instruction Manual
40” EP Gee Bee Y Scale ARF V Instruction Manual Specs: Wing Span: 40" Overall length: 30" Wing area: 306 sq. in Ready to fly weight: 28~32 oz Motor/Engine: Electric: Uranus-28309 brushless outrunner motor, 25A ESC Prop: 10x4.7, 10x5 Radio required: 4ch, 4 mini servos... -
Page 2: Return Policy
Maxford USA provides high quality, thoroughly tested model airplane kits, but ultimately the quality and capability of your finished model airplane depends on how you build it. Maxford USA can NOT in any way guarantee the performance of your finished model airplane. -
Page 3: Lithium Battery Handling & Usage
3. Take time to build straight, TRUE and STRONG. 4. Maxford USA recommends that you use a good quality radio system and our recommended or same sized good quality motor and components throughout the building process. -
Page 4: Parts List
Magnetic Battery Hatch 1 piece Vertical Stabilizer with pre-hinged rudder Horizontal Stabilizer with pre-hinged elevator Landing gear with wheels and Fiberglass Wheel Pants Tail wheel 1 piece Scale Fiberglass Cowl Hardware and accessories bag, Repair bag ©2008 Maxford USA www.maxfordusa.com... - Page 5 V1.0 need to be installed in right There is no separate motor mount. angel. There is only one way to install Motor will be installed on firewall. it on V1.1. There is no way that people can install V1.1 box wrong. ©2008 Maxford USA www.maxfordusa.com...
-
Page 6: Before You Begin
Before you begin: -Read the instructions completely before beginning assembly. -Don’t work when tired. Many aircraft (including full sized ones) have crashed because of errors made by tired builders. -Always work in a well ventilated and lighted area. ©2008 Maxford USA www.maxfordusa.com... - Page 7 There are 2 pre-installed tubes inside of the fuselage for control lines. Slide one wire into the tube on each side of the fuselage, then pull them out from the fuselage. ©2008 Maxford USA www.maxfordusa.com...
- Page 8 You have the option to glue the wood piece with the wing. If you decide to do so, you may not be able to uninstall the landing gear. Apply the long square shaped metal piece to the strut, use 2 screws to hold it. ©2008 Maxford USA www.maxfordusa.com...
- Page 9 Install motor to the firewall, then attach the fiberglass cowl to the fuselage. You should leave a gap between the edge of the cowl and the fuselage. That is the design for better cooling. Do not push the cowl down to the end. ©2008 Maxford USA www.maxfordusa.com...
- Page 10 • Attach the prop. • CG: 2 3/8” (60mm) from the wing front edge • Control Throw: Ailerons - 27mm up and down, Elevator - 25 mm up and down, Rudder - 30mm up and down ©2008 Maxford USA www.maxfordusa.com...
-
Page 11: Final Check Before Flying
This product is NOT a toy. Any use of this product is done at your own risk. Please enjoy your hobby and fly safely! Distributed by Maxford USA Corp. DBA: Green RC Models USA Address: 13909 Artesia Blvd., Cerritos, CA 90703...
Need help?
Do you have a question about the 40” EP Gee Bee Y Scale ARF V2 and is the answer not in the manual?
Questions and answers