Clutch Components (New 500, 500D Sedan And Early Station Wagon); Inspection-Diaphragm Clutch; Clutch Assembly Installed On Engine - Fiat 500L Workshop Manual

PRESSURE SPRINGS
PRESSURE PLATE
FIG 5:2
5 Finally tighten down the cover assembly using the three
T-handles and adjust the clearance between the carrier
ring and its central shoulder by means of the three
adjustment nuts.setting the withdrawal levers stroke to
0039 inch. Check this adjustment using Fiat gauge
C.110 and when correct lock the adjustment nuts by
peining to the lever bolts.
500D sedan and early station wagon:
To assemble the clutch cover assembly proceed as
described above but adjust the withdrawal levers as
follows:
1 Secure the clutch cover assembly to Fiat fixture A.62038
with a ring .5413 to .5433 inch thick placed between
the clutch cover plate and the pressure plate.
2 Adjust the height of the three withdrawal levers so that
the lever tips are 1.9094 inch from the face of the Fiat
supporting plate.
500 sedan (110.F) late 500 station wagon :
Inspection—diaphragm clutch:
To check the correct operation of the clutch cover
F500
CLUTCH COVER
WITHDRAWAL LEVERS
DRIVEN PLATE

Clutch components (new 500, 500D sedan and early station wagon)

LEVER BOLTS
LEVER CARRIER
FIG 5:3 Clutch assembly installed on engine (new
500, 500D sedan and early station wagon)
LEVER CARRIER RING
SPRING
WASHER
BOLT NUTS
61