HIKVISION DS-2CC12D5S-IT3 User Manual page 43

Steps:
1. Set the static DPC as ON, and press OK to enter the static DPC edit
interface.
2. Move the cursor to START, and press OK to start correcting the
defective pixels.
3. Press OK when you see the message of CLOSE THE IRIS THEN
PRESS ENTER KEY showing up on the screen.
The level of the STATIC DPC ranges from 0 to 60.
Some of the defective pixels may appear undistinguished for the
system to detect. You can adjust the SENS-UP to X2, X4, X6, X8, X10,
X15, X20, X25 or X30 to brighten the defective pixel for the system to
find it.

Black DPC
Black DPC is the pixel on CCD or CMOS sensor that appear
completely black, since no light is being emitted at all. Move the
cursor to black DPC and press OK to enter the black DPC
configuration interface.
HD-SDI IR Bullet Camera·User Manual
BLACK DPC
1.START
2.LEVEL
3.DIFF.TH
4.RETUEN
Figure 3-20 Black DPC
-----|------85
---|--------29
RET
42