HIKVISION Network Dome Camera Installation Manual page 12

Installation Manual of Network Dome Camera
Serial NO.
1
2
3
4
5
6
7
8
9
10
11
NOTE:
When the camera is power up, press the "INITIAL SET" button for about 10 seconds,
then all parameters, including user name, password, IP address, port number, etc., will
be reset to the factory default settings.
The alarm input is a NO/NC relay. If the input is not a NO/NC relay, follow the
connection diagram below:
Hangzhou Hikvision Digital Technology Co., Ltd. | Copyright ©
LAN(PoE): 10M/100M self-adaptive Ethernet interface
INITIAL SET: Reset all parameters to factory default settings.
AUDIO OUT: Audio output interface
MIC IN: Audio input interface
D+, D-: RS-485 interface
1A 1B, 2A 2B: Alarm output interface
IN1 GND, IN2 GND: Alarm input interface
Video output interface
Power LED indicator, which turns red when power is applied to the unit
Description
Power supply
SD card slot
4