Table of Contents
Advertisement
12.2.2 Enable DHCP Function
^
Use the "
press the Enter button
MAIN MENU
RECORD
ALARM
CLOCK / TIMER
COMMUNICATION
DISK
SYSTEM
GOTO COMM PAGE
NOTE: This function can only work if the LAN which the unit is connected to has a DHCP
server. If the DHCP server is working, the DVR will obtain an IP address automatically
from the DHCP server. In that case please skip the section 2.3 (Set IP address) and
follow section 3. (TCP/IP Communication Software).
12.2.3 Set IP Address
You don't need to set a NET IP for the unit if the LAN which the unit is connected to has a
DHCP server. Otherwise, please follow the instructions given below:
MAIN MENU
RECORD
ALARM
CLOCK / TIMER
COMMUNICATION
DISK
SYSTEM
GOTO COMM PAGE
^
Use the "
" and "v" buttons
to enter the NET IP page
Set the IP, MASK and GATEWAY. Then press the Enter button
following is a sample setting.
IP:
MASK:
GATEWAY:
* About the location of the buttons, please refer to Page 10 2.1 Front View.
" and "v" buttons
, and
to proceed.
, and
, to highlight the NET IP. Press the Enter button
192.168.0.1
255.255.255.0
0.0.0.0
, to highlight NET DHCP; select ON. Then
COMM SETTING
COMM ID
RS232
RS485
NET ENABLE
NET DHCP
NET IP
FTP SETTING
MAIN PAGE
SET ETHERNET DHCP
COMM SETTING
COMM ID
RS232
RS485
NET ENABLE
NET DHCP
NET IP
FTP SETTING
MAIN PAGE
SET ETHERNET
74
: 01
: ON
: ON
: ON
: ON
: SET
: 01
: ON
: ON
: ON
: ON
: SET
to proceed. The
Advertisement
Table of Contents
