Table of Contents
Advertisement
4.2 Recording Operations
This section details the way to record video into hard-disk drives. Before commencing with the recording
function, please configure the recording setting properly according to your needs.
4.2.1 Manual Recording
When the DVR is in live display mode, take the following steps to start recording:
(1) In live display, press the REC button
corresponding programmed recording settings. The monitor should display a flashing REC
message and the REC button
(2) Press the STOP button
(3) To access just recorded video, please refer to section 4.4 for more details.
4.2.2 Timer Recording
Timer recording provides two periods of time each day in a weekly table which programs the DVR
to turn on and off at specified times. This way the DVR will start and stop recording according to
the programmed schedule. Please take the following steps to program the scheduled recording.
(1) Press the Setup button
(2) Select the CLOCK / TIMER and press the Enter button
page.
(3) Select the TIMER－SET.
(4) Press the Enter button
(5) ● You can set up by using the "<" button
day/hour/minute and use the "
day/hour/minute you wish.
● You can also set up by using the Shuttle Ring and the Jog Dial.
"<" button
and
● The time is displayed in a 24-hour clock format.
(6) After scheduling is completed, press the Enter button
select CANCEL to leave the page without saving the settings.
(7) To activate the programmed recording schedule, set the REC ENABLE to ON. As the
scheduled recording is on, the red indicator of the Timer Record
deactivate it, set to OFF.
(8) Press the STOP button
to continue the scheduled recording, press the REC button
* About the location of the buttons, please refer to Page 10 2.1 Front View.
to stop recording any time.
to enter the MAIN MENU.
to enter the REC SCHEDULE table.
,
is the equal of the ">" button
is the equal of the "v" button
during the scheduled recording to stop it at any time. If you wish
to record video into a hard-disk drive with the
will light up indicating the DVR is in the recording status.
and the ">" button
^
" button
and the "v" button
,
.
25
to enter the CLOCK / TIMER
to locate the specific
to set the
is the equal of the
^
is the equal of the "
" button
and set OK to save the setting or
will be on as well. To
to proceed.
Advertisement
Table of Contents
