Table of Contents
Advertisement
3.3 System Information
You can display system settings information as shown on Table 3.3 A below at any time by pressing
the Display button
recording mode, the Manual Recording information is displayed. However, when the DVR is displaying
a decoded image from a multiplexer, you must first switch the unit to encoded image displaying (The
pictures is switching swiftly and the light of Monitor button
. Each sequential press of the Display button
following example. By default, the unit displays time, date, and an indicating bar of capacity status on a
monitor as shown next.
Default display
(Capacity Used)
09-05-2003
(Date)
Press the Display button
display. Press the Display button
button one more time to back to the default display.
Table 3.3 A.
1+ 2: 59G
QUALITY: BEST
RATE: 6 HR
MUX : OFF
HD P
SIZE
1
Y
20 G
2
Y
39 G
IP : 192 . 168 . 1 . 90
* About the location of the buttons, please refer to Page 10 2.1 Front View.
. In the playback mode, the recorded video information is displayed. In the live or
(Capacity Remaining)
16:13:02
(System Time)
once; the DVR will display the following sample message plus the default
again; the unit will not display any OSD message. Press the
12.4 HR
NTSC
20 F/S
9K
POS
39.5% P
0.0% R
is off) by pressing the Monitor button
displays a different message detailed in the
The TOP
Current
of the HDD
Position
Description of Table 3.3 A
(1+2: 59G): Total capacity of installed hard-disk, 59 GB
(12.4 HR): Total 12.4 hour recording time available
(
): Timer record activated
(
): Alarm record activated
(QUALITY: BEST): Record quality setting, BEST
(NTSC): NTSC system
(RATE: 6 HR): Setting of Record time mode, 6 hours
(20 F/S): Record speed setting, 20 fields/sec
Only connected to a single camera.
(MUX: OFF):
(
): Audio function activated
(
): Indicate which HDD is activated
(9K): The image file size
(HD): Hard-disk Compartment
(P): Y Hard-disk installed; . No hard-disk installed
(SIZE 20G): The capacity of the installed hard-disk
(POS): Percentage of system; R: Recording; P: Playback
(IP : 192 . 168 . 1 . 90): Setting of
communication,192.168.1.90
( )
: External signal
X
(
): Cannot operate at now
20
The END
of the HDD
the Ethernet
Advertisement
Table of Contents
