Table of Contents
Advertisement
Locating beginning of timer
H
recordings
At the press of a button, you can turn on the VCR,
rewind the tape and begin to view the most recent timer-
recorded program.
Press REVIEW on the Remote after ensuring that the
VCR is in the timer recording standby mode.
The VCR turns on, and rewinds to the index code
indicating the beginning of the last timer-recorded
program, then begins playback automatically.
You can access a program of 2 to 9 index codes away
from the current position on the tape. If, for example,
you have 5 programs recorded and you want to watch
the third one, press REVIEW three times.
If you want to find the very beginning of the desired
program, press REW (
SHUTTLE ring after playback starts.
If the tape is already rewound when REVIEW is
pressed, it will play the tape from the beginning. It will
not fast-forward to an index code.
The Instant Review function will also operate if the
VCR is turned on.
Skipping unwanted portions
I
— Skip Search
You can skip over (view at high speed) unwanted
portions of the tape.
Press SKIP SEARCH on the Remote once to 4 times
during playback.
Each press initiates a 30-second period of high speed
playback (up to 2 minutes). When the specified portion
of the tape is skipped, normal playback resumes
automatically.
To return to normal playback during Skip Search, press
PLAY ( 3 ).
— Instant Review
) or FF (
) or turn the
Adjusting picture condition
J
— Digital 3-DNR (S-VHS/VHS only)
The Digital 3-DNR (3-Dimension Noise Reduction) cuts
noise and reproduces clear pictures. Normally turn on
Digital 3-DNR.
The playback picture may be distorted depending on the
tape. In this case, turn off Digital 3-DNR.
Press DIGITAL 3-DNR on the front panel so that the
DIGITAL 3-DNR lamp lights up.
Each time you press the button, this function turns on
and off.
Other Useful functions for playback
(S-VHS/VHS only)
You can also use the following functions for playback.
Video Calibration (S-VHS/VHS only) (
When this function is set to "ON", this VCR checks the
condition of the tape in use during playback and
recording, and compensates to provide the highest-
possible pictures.
Picture Control (
pg. 49)
This function helps you to adjust the playback picture
quality according to your preference.
Digital R3 (
pg. 49)
This function applies edge correction to the luminance
signal to enhance details and provides clear pictures.
Video Stabilizer (
pg. 49)
You can automatically correct vertical vibrations in the
picture when playing back unstable recordings made on
another VCR.
25
EN
pg. 49)
Advertisement
Table of Contents
