Hookup And Settings; Connecting An Antenna Or Cable Tv - JVC LVT2016-001D Instructions Manual

Hookup and Settings

Depending on your TV and other equipment
there are various ways you can connect the
recorder. Please refer to the manuals of your
TV, VCR, Stereo System or other devices as
necessary for additional connection informa-
tion.
Notes:
Make sure the Recorder is connected directly to the TV
•
and tune the TV to the correct video input channel.
Do not connect the Recorder's AUDIO OUTPUT jack to
•
the phono in jack (record deck) of your audio system.
Do not connect the Recorder via another VCR. The
•
DVD image could be distorted by the copy protection
system.
The picture and sound of a nearby TV, VCR, or radio
•
may be distorted during playback. Position the units
away from each other or turn off the unit after removing
the disc.
Connecting an
Connecting an
or Cable TV
or Cable TV
a a Antenna
:
Disconnect the antenna from the rear of the TV and
identify the antenna cable. If it is a round 75 ohm
coaxial cable connect it directly to the jack marked
ANTENNA IN on your Recorder. If your antenna
cable is flat connect it to a 300-ohm to 75-ohm anten-
na adaptor (not supplied) and slip the adaptor over
the ANTENNA IN jack. Don't attempt to screw it into
to the Recorder.
b Cable TV (RF Connection): b
If your cable connection requires a cable box use
option #2 from the hookup diagram. Use the cable
box to tune the channels and set the JVC tuner to
CH3 or CH4 depending on your cable box.
If your cable connection does not require a cable box
use option #1 from the hookup diagram. Attach the
cable from the wall to the ANTENNA IN jack on this
unit and then perform either the Initial Setup Wizard
or Auto Channel Set.
c c Cable TV (A/V Connection):
Alternatively, option #3 can also be used if you cable
box has A/V outputs. Use the cable box to tune the
channels and set the JVC to the AV1 input by press-
ing the AUX button of the JVC remote control.
10
Antenna
Antenna
a
Antenna Antenna
OR OR
Rear of Recorder
b
To view or record a CATV channel
1. Connect the recorder to the TV by method
explained page 11 or 12.
2. Set the recorder channel selector to the cable out-
put channel (example CH3) if using hookup option
#2 or AV1 input if using hookup option #3.
3. Select a channel using the cable converter.
Notes:
With hook up options #2 and #3, you cannot record one
•
program while viewing another.
If you are using a cable box to tune channels, it is not
•
necessary to do Auto Channel Set.
For DVD/VCR playback, Menu, or tuner viewing connect
•
the recorder to the TV using the A/V or HDMI connec-
tions.
c