JVC HM-HDS4EK Instructions Manual page 90

90
Set Stations (A)
Set station names that are registered in your recorder.
Perform steps A and C of "Manual Channel Set" on page 88
to access the Confirmation screen before continuing.
A
Select the item.
Press until the item you want begins blinking.
w r e t
B
Access the Manual Channel Set screen.
Press OK twice.
C
Select the new station.
Press until the station
e
name (ID) begins blinking,
then press until the new
rt
station's name (ID) you want
to store begins blinking.
Registered station names
( pg. 91) appear as you
press .
rt
D
Switch the stations.
Press OK.
The Confirmation screen appears.
Repeat steps A – D as necessary.
E
Close the Confirmation screen.
Press MENU.
Set Stations (B)
Set station names other than the ones registered in your recorder.
Perform steps A and C of "Manual Channel Set" on page 88
to access the Confirmation screen and then perform steps A
and B of "Set Stations (A)" in the left column before
continuing.
A
Select the character for station name.
Press until the first letter of
e
the station name begins
blinking.
B
Enter the new character.
Press to cycle through the characters (A–Z, 0–9, –,
rt
+, (space) ) and stop when the desired character is
I
indicated, then press
e
to enter. Enter the remaining
SUBSIDIARY SETTINGS (cont.)
characters the same way (maximum of 4). After entering
all characters, press OK.
The Confirmation screen appears.
If you make a mistake, press
begins blinking. Then enter the correct character by pressing
.
rt
C
Close the Confirmation screen.
Press MENU.
NOTE:
The characters available for the station name (ID) are A–Z, 0–9,
–, , +, (space) (maximum of 4).
f I
Fine-Tuning Channels Already Stored
Perform steps A and C of "Manual Channel Set" on page 88
to access the Confirmation screen before continuing.
A
Select the channel to fine-tune.
Press until the channel you want to tune begins
w r e t
blinking.
B
Access the Manual Channel Set screen.
Press OK twice. The Manual Channel Set screen appears.
C
Perform tuning.
Press until "+/–" begins blinking, then press
e
the picture is its clearest. Then press OK.
The Confirmation screen appears.
Repeat steps A – C as necessary.
D
Close the Confirmation screen.
Press MENU.
,
f
until the incorrect character
w
rt
until