JVC HM-HDS4EK Instructions Manual page 81

AUTO SP LP TIMER
8 ]
ON
OFF
VCR SET UP 2
B.E.S.T.
8
ON
OFF
PICTURE CONTROL
8
AUTO
EDIT
SOFT
SHARP
VIDEO STABILIZER
8
ON
OFF
When this function is set to "ON", the recorder automatically switches to LP mode to allow complete
recording if there is not enough tape to record the entire programme while timer-recording in SP
mode.
For Example . . .
Recording a programme of 210 minutes in length onto a 180-minute tape
Approximately 150 minutes
SP mode
Total 210 minutes
Make sure you set this function to "ON", before the timer-recording starts.
NOTES:
If you have programmed the recorder to timer-record 2 or more programmes, the second programme
and those thereafter may not fit on the tape if you set "AUTO SP
make sure the mode is not engaged, then set the tape speed manually during timer programming.
In order to ensure that the recording fits on the tape, this feature may leave a slight non-recorded
section at the end of the tape.
There may be some noise and sound disturbance at the point on the tape where the recorder
switches from SP to LP mode.
The Auto SP LP Timer feature is not available during ITR (Instant Timer Recording), and the feature
]
will not work properly with any tapes longer than E-180, or with some tapes of shorter lengths.
If you perform timer recording with both PDC and the Auto SP
programme goes beyond its originally scheduled length, there may be times when the programme
cannot be recorded in its entirety.
You can set the B.E.S.T. (Biconditional Equalised Signal Tracking) system to "ON" or "OFF"
( pg. 45).
This feature helps you to adjust the playback picture quality according to your preference. Normally
select "AUTO".
AUTO
: Provides the optimised picture benefits of the B.E.S.T. Picture System.
EDIT
: Minimizes picture degradation during editing (recording and playback).
SOFT
: Reduces image coarseness when viewing overplayed tapes containing a lot of
noise.
SHARP
: Clearer, sharper-edged picture when viewing images with lots of flat,
same-coloured surfaces such as cartoons.
NOTES:
When you select "EDIT", "SOFT" or "SHARP", the selected mode will not change until you select
another mode.
When you select "EDIT" to dub tapes, be sure to select "AUTO" after you finish dubbing the tapes.
When "B.E.S.T." is "OFF", "PICTURE CONTROL" switches automatically from "AUTO" to "NORM".
When this function is set to "ON", you can automatically correct vertical vibration in the picture when
playing back unstable recordings made on another recorder.
NOTES:
When you finish viewing a tape, be sure to set this function to "OFF".
Regardless of the setting, this function has no effect during recording and during special effects
playback.
The on-screen display may jitter vertically when this function is set to "ON".
To watch recordings with close-caption, set this function to "OFF".
Approximately 60 minutes
LP mode
* The default setting is bold in the table below.
LP TIMER" to "ON". In this case,
]
LP Timer activated, and the
]
81