Related Manuals for Minuteman BP192RTXL
Summary of Contents for Minuteman BP192RTXL
- Page 1 BP192RTXL BP240RTXL Battery Packs User's Manual Para Systems, Inc. 1455 Lemay Dr. Carrollton, TX 75007 Phone: 1-972-446-7363 Fax: 1-972-446-9011 Internet: minutemanups.com UPS Sizing: sizemyups.com P/N 34000472 R2...
-
Page 2: Table Of Contents
Table Of Contents Introduction Rear Panels Installation Operation Replacing the Battery Obtaining Service Specifications Limited Product Warranty... -
Page 3: Introduction
VICE PERSONNEL ONLY. read this manual before installing your BPRTXL Battery Pack, models BP192RTXL, BP240RTXL as it provides important information that should be WARNING: Risk of Electrical Shock. Hazardous live parts inside these Bat- followed during installation and maintenance of the Battery Packs and batter- tery Packs are energized from the battery. - Page 4 NOTICE: This equipment has been tested and found to comply with the limits LIFE SUPPORT POLICY for a Class A computing device in accordance with the specifications in Sub- As a general policy, we do not recommend the use of any of our products in part J of Part 15 of FCC Rules and the Class A limits for radio noise emissions life support applications where failure or malfunction of the product can be from digital apparatus set out in the Radio Interference of the Canadian De-...
-
Page 5: Rear Panels
Chapter 2: Rear Panels Chapter 3: Installation INSTALLATION PLACEMENT This Battery Pack series is ONLY intended to be installed in an indoor tem- perature controlled environment that is free of conductive contaminants. DO NOT operate the Battery Pack in: extremely dusty and/or unclean areas, loca- tions near heating devices, water or excessive humidity, or where the Battery Pack is exposed to direct sunlight. - Page 6 RACKMOUNT CONFIGURATION TOWER CONFIGURATION The tower configuration allows the user to install the Battery Pack in the up- Use the included rackmount brackets and screws to mount the Battery Pack in right position. The tower stands are provided with the Battery Pack. WARN- a rack by following the steps below.
- Page 7 NOTE: If you are using more than one of these Battery Packs with the 4. Remove both of the External Battery Connector's cover plates from the Endeavor 5-10KVA RT series UPS, the UPS must be configured so that the rear panel of the first Battery Pack. UPS will report the correct estimated runtime on the LCD screen and in the 5.
-
Page 8: Operation
Chapter 5: Replacing The Battery (QUALIFIED SERVICE PERSONNEL ONLY) BP240RTXL Model BP192RTXL Please read all of the WARNINGS and CAUTIONS before attempting to con- nect or service the batteries or the Battery Pack. The installation and servic- Battery B00056... - Page 9 BATTERY REPLACEMENT PROCEDURE 24. Properly dispose of the old batteries at an appropriate recycling facility or (QUALIFIED SERVICE PERSONNEL ONLY) return them to the supplier in the packing material for the new batteries. 25. The Battery Pack is ready for normal operation. PLEASE READ THE CAUTIONS AND WARNINGS BEFORE ATTEMPTING NOTE: If the UPS has a Weak/Bad Battery Alarm after replacing the batter- TO REPLACE THE BATTERY MODULES...
- Page 10 BP192RTXL 31. Reconnect all of the battery cables. 32. Turn on all of the DC circuit breakers on the rear panel of all of the Battery (QUALIFIED SERVICE PERSONNEL ONLY) Packs. 1. Turn off the equipment that is plugged into the output receptacles of the 33.
-
Page 11: Obtaining Service
Chapter 6: Obtaining Service Chapter 7: Specifications IF THE BATTERY PACK REQUIRES SERVICE SYSTEM SPECIFICATIONS Model Number BP192RTXL BP240RTXL 1. Verify there are no tripped circuit breakers and that the batteries are good. Format Rack/Tower Convertible A tripped circuit breaker and defective batteries are the most common iss- BATTERY SYSTEM ues. -
Page 12: Limited Product Warranty
Chapter 8: Limited Product Warranty Notes: Para Systems, Inc. (Para Systems) warrants this equipment, when properly applied and operated within specified conditions, against faulty materials or workmanship for a pe- riod of three years from the date of purchase. For equipment sites within the United States and Canada, this warranty covers depot repair or replacement of defective equip- ment at the discretion of Para Systems.