Table Of Contents Introduction Rear Panel Installation Obtaining Service Replacing the Battery Specifications Limited Product Warranty Declaration of Conformity...
Standard for the Protection of Electronic Computer/Data Pro- this manual before installing your Encomapss BPXL Battery Pack series, models cessing Equipment ANSI/NFPA 75. BP24XL, BP48XL, BP72XL as it provides important information that should be followed during the installation and the maintenance of the Battery Pack allow- WARNING: These Battery Packs contains potentially hazardous voltages.
Page 4
NOTICE: This equipment has been tested and found to comply with the limits Life Support Policy for a Class A computing device in accordance with the specifications in Sub- As a general policy, we do not recommend the use of any of our products in part J of Part 15 of FCC Rules and the Class A limits for radio noise emissions life support applications where failure or malfunction of the product can be from digital apparatus set out in the Radio Interference of the Canadian De-...
Chapter 2: Rear Panel Chapter 3: Installation INSTALLATION PLACEMENT This Battery Pack series is ONLY intended to be installed in an indoor tem- perature controlled environment that is free of conductive contaminants. DO NOT operate the Battery Pack in: extremely dusty and/or unclean areas, loca- tions near heating devices, water or excessive humidity, or where the Battery Pack is exposed to direct sunlight.
Page 6
CONNECTING THE BATTERY PACK 9. The Battery Pack is ready for normal operation, see the UPS User's Manual NOTE: When using these Battery Packs, the UPS must be configured so that for the normal startup of the UPS. the UPS will report the correct estimated runtime on the LCD screen and in the Power Monitoring software and/or the SNMP card.
5. Mark the RMA # on the outside of all packages. The factory cannot accept any package without the RMA # marked on the outside. 6. Return the unit by insured, prepaid carrier to: Para Systems Inc. MINUTEMAN UPS 1809 W. Frankford Road, Suite 150 Carrollton, TX 75007 ATTN: RMA # _______...
23. The Battery Pack is ready for normal operation. NOTE: If the UPS has a Weak/Bad Battery Alarm after replacing the battery mod- BP24XL BP48XL BP72XL Model # ules, the user must initiate a self test to clear the Weak/Bad Battery Alarm.
Para Systems, Inc. (Para Systems) warrants this equipment, when properly applied and operated within specified conditions, against faulty materials or workmanship for a pe- Model Number BP24XL BP48XL BP72XL riod of three years from the date of purchase. For equipment sites within the United...
Standard(s) to which Conformity is declared: EN62040-2, IEC61000-2-2 IEC61000-4-2, IEC61000-4-3, IEC61000-4-4, IEC61000-4-5, IEC61000-4- 6, IEC61000-4-8, UL1778, CSA 22.2 no. 107.3-14, FCC Class A Manufacturer’s Name: Para Systems, Inc. (MINUTEMAN UPS) Manufacturer’s Address:1455 LeMay Drive Carrollton, Texas 75007 USA Type of Equipment: Uninterruptible Power Supplies (UPS)
Need help?
Do you have a question about the BP24XL and is the answer not in the manual?
Questions and answers