JVC HR-XVC29SU Instructions Manual page 68

68
EN
TIMER RECORDING (VCR deck)
SYMPTOM
1. Timer recording won't work.
2. Timer programing is not possible.
3. "#" on the front display panel won't
stop blinking.
4. "#", " " and "$" on the front
display panel won't stop blinking.
5. "#" blinks for 10 seconds and the
Timer mode is disengaged.
6. " " and "$" on the front display
panel won't stop blinking.
7. "N", " " and "$" on the front display
panel won't stop blinking.
POSSIBLE CAUSE
The clock and/or the timer have been set
incorrectly.
The timer is not engaged.
Timer recording is in progress.
The timer is engaged but there's no
cassette loaded.
The loaded cassette has had its record
safety tab removed.
The end of the tape was reached during
timer recording.
TIMER has been pressed when there are
no programs in memory, or the timer
record information has been programed
incorrectly.
The end of the tape was reached during
Instant Timer Recording.
The Satellite Auto Recording mode is
engaged but there is no cassette loaded.
The loaded cassette has had its record
safety tab removed.
The end of the tape was reached during
Satellite Auto Recording.
TROUBLESHOOTING (cont.)
CORRECTIVE ACTION
Re-perform the clock and/or timer
settings.
Press TIMER and confirm that "#" is
displayed on the front display panel.
Timer programing can't be performed
while a timer recording is in progress.
Wait until it finishes.
Load a cassette with the record safety tab
intact.
Remove the cassette and cover the hole
with adhesive tape, or insert a cassette
with the record safety tab intact.
The program may not have been recorded
in its entirety. Next time make sure you
have enough time on the tape to record
the entire program.
Check the programed data and re-
program as necessary, then press TIMER
again.
The program may not have been recorded
in its entirety. Next time make sure you
have enough time on the tape to record
the entire program.
Load a cassette with the record safety tab
intact.
Remove the cassette and cover the hole
with adhesive tape, or insert a cassette
with the record safety tab intact.
The program may not have been recorded
in its entirety. Next time make sure you
have enough time on the tape to record
the entire program.