Remote; Remote Control Functions - JVC HR-XVC29SU Instructions Manual

56
EN
Remote Control
Functions
Remote A/B/C/D Code Switching
The Remote is capable of controlling four JVC video units
independently. Each of units can respond to one of four codes
(A, B, C or D). The remote control is preset to send A code
signals because your unit is initially set to respond to A code
signals. You can easily modify your unit to respond to B, C or D
code signals.
Before performing the following steps:
Slide the TV/VCR/DVD switch on the Remote to the right.
Slide to the
right.
Number keys
POWER
On the Remote
Keep pressing VCR down during steps A – B.
A
Press the number key "1" for A, "2" for B, "3" for C or
"4" for D.
B
Press ENTER to set the code.
NOTE:
Once the batteries are removed, the remote control code is back
to A.
On the unit
A
Press POWER on the unit.
B
VCR
Press 4 PLAY on the unit for over 5 seconds while the
unit is turned off. The code currently set appears on the
front display panel.
If the code displayed on the front display panel is different
from the code set on the Remote, go to step C.
C
Press 8 STOP on the Remote. The code currently set on
the Remote will be applied to the unit.
NOTE:
ENTER
Even if you unplug the end of the mains power cord from the
mains, the code currently set remains.
7 STOP
3 PLAY
Change the remote control code.
Set the remote control code.
Turn off the unit.
Display the code.
Change the unit's code.

REMOTE