Table of Contents
Advertisement
Installation
Attaching cables/RJ31X Jack Installation
A telephone cord terminated with an RJ31X connector is provided for telephone
connection. This ensures that the Console will ALWAYS dial out when tripped, even if the
phone line is busy at the time. Note the RJ31X jack to which you connect the Console
might have to be installed by the phone company.
The wiring diagram for an RJ31X connector is shown below. The connections labeled R
and T should be connected to the Tip & Ring connections coming into the house from the
telephone company. You then connect the red and green that goes to all the phones in the
house to T1 and R1. When the RJ31X plug is removed, the shorting bars connectsT1 to T
and R1 to R. When the RJ31X plug is inserted it opens this path, but the PRO2000 panel
closes this connection again. When an alarm occurs the PRO2000 opens this connection
(to disconnect all phones in the house) and dials out on the yellow and black wires which
are connected to T and R.
FROM
TELEPHONE
COMPANY
RJ31X
RECEPTACLE
BLOCK
MALE
RJ31X PLUG
FROM PRO2000
®
™
Tampa, FL33618
RED
YELLOW BLACK
WIRE COLORS IN CABLE FROM PRO2000
GREEN
7
Technical Support: 800 832 4003
RJ31X
Jack
TO
HOME
PHONES
SHORTING BARS
SHORT REMOVED
ON PLUG INSERTION
PRO2000_DR/AB-6/98
Advertisement
Table of Contents
