Table of Contents
Advertisement
Troubleshooting
PROBLEM
If the armed indicator is flashing.
If the POWERHORN does not trip when
the alarm trips.
The Motion Detector causes false
alarms.
The MONITOR light is flashing.
®
™
Tampa, FL33618
SOLUTION
This indicates that there has been an
intrusion. Also, if a zone indicator is on,
this indicates which zone was violated. To
turn the zone indicator off, and stop the
armed indicator from flashing press ARM
then DISARM on the remote control. If a
zone indicator is not lit, the violated zone
may have been one of the second eight
zones. Press BYPASS to see which zone
was tripped.
• Be sure you set the dials on the
POWERHORN to the same House
Code and Unit Code as the Security
Light downloaded to the Console
(default A13).
• Plug the POWERHORN into another
outlet near the Console.
• All brands of motion detectors sense
motion by detecting a change in
temperature, therefore do not place
the detector near any sources of heat
such as over an air conditioner or
heating vent.
• Do not place in a direct source of
bright light, such as sunlight. Do not
point directly toward a window.
• Do not place near cellular 'phones or
microwave ovens.
This means that you need to call the
installing security firm to set up of the
console. After installation, this could be
caused by a failure to communicate with
the monitoring station over the phone
lines. Check for proper RJ31X
installation: see page 7.
28
Technical Support: 800 832 4003
PRO2000_DR/AB-6/98
Advertisement
Table of Contents
