Table of Contents
Advertisement
Installation
Keychain Remote
Registering the Keychain Remote with the Security Console
• Fit two AAA Alkaline batteries in the battery compartment in the back of the Keychain
Remote.
• Press and hold the ARM button for about a second. The LED indicator flashes twice
when you release it. This confirms the Keychain Remote has generated a new
security code.
• Set the slide switch on the Security Console to INSTALL.
• Press ARM. The console chimes once to confirm that the Keychain Remote has been
registered.
• Return the console slide switch to the RUN1 or RUN2 position.
Testing the Keychain Remote
• Set the slide switch on the Security Console to RUN1 or RUN2.
• Press ARM on the Keychain Remote. The console chimes once to confirm and the
ARM indicator lights. Press DISARM.
Note: The Keychain Remote always arms the system instantly - there is no exit or
entry delay.
• Press LIGHTS ON and LIGHTS OFF to turn on and off a light connected to a lamp
module with code dials set to A13 (or other code downloaded during installation).
• Press ARM and DISARM together to trip the panic alarm. Press DISARM to stop the
alarm.
®
™
Tampa, FL33618
10
Technical Support: 800 832 4003
PRO2000_DR/AB-6/98
Advertisement
Table of Contents
