Digital Audio For Better Sound Quality - JVC 0905TNH-FN-FN Instructions Manual

Recording from a camcorder or other
Audio-Video equipment with no Scart output
jack (AV3)
If no S-Video input jack is available, connect to
VIDEO input jack on the front panel using an RCA
Video cable.
Change the setup when using S-VIDEO input jack.
(See page 33.)
AV3 (Front)
DUBBING
R VCR/DVD DVD
VCR DVD
S-Video cable
(not supplied)
S-VIDEO
OUT

Digital Audio for Better Sound Quality

(Only for DVD)
Digital audio
input jack
COAXIAL
Coaxial cable
(not supplied)
AV2(DECODER)
The connections illustrated above are
optional for better sound.
1
For clear digital sound quality, use
the COAXIAL DIGITAL AUDIO OUT
jack to connect your digital audio
equipment.
If the audio format of the digital output does not
match the capabilities of your receiver, the
receiver will produce a strong, distorted sound or
no sound at all.
18
EN
S-VIDEO VIDEO (MONO) L-AUDIO-R
Audio cable
(not supplied)
AUDIO
OUT
Dolby Digital decoder,
DTS decoder or
MPEG decoder, etc.
DVD
DIGITAL AUDIO S-VIDEO
AUDIO OUT OUT OUT
L
COAXIAL
R
DVD/VCR DVD ANTENNA
DIGITAL AUDIO S-VIDEO
AUDIO OUT OUT OUT
IN
L
COAXIAL
AV1(TV)
OUT
R
Connecting a Dolby Digital™ decoder, DTS
decoder or MPEG decoder
• Connecting multi-channel Dolby Digital decoder
allows you to enjoy the 5.1ch Dolby Digital surround
system as well as DTS decoder, 5.1 channel
surround system.
• After connecting to a Dolby Digital decoder, set
"Dolby Digital" to "Stream" in the audio menu. (See
page 61.)
• After connecting to a DTS decoder, set "DTS" to
"ON" in the audio menu. (See page 61.)
• After connecting to a MPEG decoder, set "MPEG" to
"Stream" in the audio menu. (See page 61.)
Connecting to an MD deck or DAT deck
• The audio source recorded in Dolby Digital 5.1
channel surround format cannot be recorded using
an MD or DAT deck as a digital sound.
• If not connected to a Dolby Digital decoder, set
"Dolby Digital" to "PCM" in the audio menu. Playing
back a DVD using incorrect settings may generate
noise distortion, and damage speakers.
• Set "Dolby Digital," and "MPEG" to "PCM" and set
"DTS" to "OFF" in the audio menu for connecting to
an MD or DAT deck.
• You can use AUDIO OUT jacks for the connection of
your audio system.
After You Have Completed
Connections
Switch the input selector on your TV to an appropriate
external input channel. For details, refer to the
Instruction Manual of your TV.
Note
• Connect this unit directly to the TV. If the Audio/
Video cables are connected to a VCR, pictures may
be distorted due to the effects of the copy protection
system.