Settings For External Equipment - JVC 0905TNH-FN-FN Instructions Manual

If programming has been made at the end of the
programming (PROG. 1) currently being recorded:
• The timer programming set first (PROG. 2) has
priority. PROG. 3 will not be recorded.
PROG. 1
PROG. 2
PROG. 3
Actual
PROG. 1
recording
Additional 30 seconds (at the most) are cut off.
If the recording time is partially overlapped:
• The timer programming with the earlier start time
(PROG. 2) has priority. PROG. 1 will start after
PROG. 2 recording is complete.
PROG. 1
PROG. 2
Actual
PROG. 2
recording
Additional 30 seconds (at the most) are cut off.
If the recording time entirely overlaps:
• The shorter timer programming (PROG. 1) is not
recorded.
PROG. 1
PROG. 2
Actual
PROG. 2
recording
Note for DVD recording
• If the recording time of two programmes overlap, or
the End time of a programme and the Start time of
another is same, the first 30 seconds (at the most)
of the subsequent programme are cut off.
If the End time of the programme currently being
recorded and the Start time of the subsequent
programme are same:
• If PROG. 1 is a DVD recorded programme, the
beginning of PROG. 2 may be cut off.
PROG. 1
PROG. 2
Actual
PROG. 1
recording
* If the cut off time exceeds 1 minute, the error
number "E40" will appear in the timer programming
list.
PROG. 2
recording
will start
after
PROG. 1
recording is
PROG. 2
completed.
PROG. 1
PROG. 2
The first 30 seconds
(at the most) are cut off.*

Settings for External Equipment

Connection to External Equipment
Video VR
DVD-RW DVD-RW DVD-RW DVD-RW
Connect the external equipment using either the input
jacks, AV1, AV2 (Rear) or AV3 (Front). However, for
AV3 jacks, you have to select S-VIDEO input or
VIDEO input jacks depending on the connected
devices.
Use commercially available Scart, S-Video or Video
cable and an Audio cable for this connection.
1
In stop mode, press [SET UP].
2
Select "Advanced Setting Menu"
using [Cursor U / D], then press
[ENTER].
If it has already appeared, proceed to step 3.
3
Select "Select Video" using
[Cursor U / D], then press [ENTER].
4
Press [ENTER].
5
Select the input jack type to be used
using [Cursor U / D], then press
[ENTER].
AV3 (Front)
Video In
S-Video In
• If you want to use VIDEO input jack (Composite),
select "Video In."
• If you want to use S-VIDEO input jack, select
"S-Video In."
6
Press [SET UP] to exit.
VCR VCR VCR
DVD-R DVD-R
VCR DVD
33
EN