Advertisement
_____________________________________________________________________________
6. Now, collapse the antenna sections. Hold the base tube firmly in one hand
and twist section above the base tube while pushing it down slightly toward
the base tube until the tube collapses into the base tube.
7. Before collapsing any other sections, if required, pull any slack in the vertical
element wire out from the bottom of the base tube.
8. Thread the male bullet connector through the small hole in the end cap center
piece and then screw the bottom end cap back onto the base tube.
9. From the base tube, collapse the remaining antenna sections one-by-one by
twisting and pushing them into the base tube.
NOTE: Keep an eye on the vertical element wire to ensure
that it does not get pinched in the base tube.
10. When all of the sections are in the base tube, push the rubber end cap
into the top of the base tube.
11. Loop the vertical element wire around the base tube and you're ready
to go!
MAINTENANCE
The S9v requires little, if any, maintenance. The S9v is finished with a durable
painted surface, but it is subject to oxidation – just like an aluminum antenna. If
you notice surface oxidation (color becomes lighter), use a soft cloth and Armor
TM
All
to restore the finish. Automotive spray wax is also an excellent product to
seal and protect the finish. The S9v may also be repainted, if desired, using a
quality exterior spray paint such as Krylon
you lightly dull the finish and then prime it with a quality primer before you paint it.
________________________________________________________________________
S9v 18' M k II Installation Guide
TM
TM
or Rustoleum
23
. It is suggested that
Advertisement
