Advertisement
_____________________________________________________________________________
ABOUT THE TUBE RINGS (Con't)
Next, slide the ring down the tube to see if it fits tightly against the top
-
edge of the adjoining lower tube.
If the ring is not tight, slide the ring back up the tube, use your thumb and
-
index finger to advance the latch ONE MORE CLICK. Repeat the previous
step and this step until the ring fits tightly against the top edge of the lower
tube section as shown above.
-
Once a tube ring is properly latched, there is no need to unlatch or change
the ring latch setting – simply slide the rings on and off the tubes each time
you assemble or disassemble the antenna.
________________________________________________________________________
S9v 18' M k II Installation Guide
10
Advertisement
