Advertisement
_____________________________________________________________________________
j. Note how the rubber band is looped around itself on the tip of the
connector. Now, remove the rubber band from the connector and
unscrew the black plastic cap from the bottom of the S9v base tube. Next,
poke the bare connector through the hole near the center of the black
plastic cap and remove the cap. Hang on to the cap as we will screw it
back on in a few steps.
k. Now, re-attach the rubber band. Be sure to loop it tightly around the metal
tip of the connector as shown below.
l.
Fully extend the section above the base tube. The bullet connector and
rubber band will disappear into the base tube as the upper section is fully
expanded.
m. Now, install the largest tube ring on the section above the base tube like
we did with the thinner, upper sections.
________________________________________________________________________
S9v 18' M k II Installation Guide
17
Advertisement
