Brother PE-180D Service Manual page 13

22. Remove the two screws of the bushing fixation and then remove the vertical shaft.
23. Remove the three screws of the rotary hook shaft frame assembly and then remove the rotary hook unit.
24. Remove the screw and then remove the circuit board mounting plate.
25. Remove the three screws and then remove the power supply unit cover.
26. Remove the screw and then remove the switch holder.
27. Remove the three screws and then remove the power supply unit.
28. Remove the four screws and then remove the main frame.
29. Remove the two screws and then remove the inlet assembly.
- 11 -