Table of Contents
Advertisement
Table 3. Default IP addresses based on switch module bay numbers (IP Setup window
of Telnet Basic Setup menu)
Bay number
Bay 1
Bay 2
Bay 3
Bay 4
To set up the switch module for remote management, highlight IP Setup from
the main menu. The following window appears:
The switch module must have an IP address assigned to it so that a network
management system (that is, Telnet) client can find it on the network.
The switch module must have an IP address assigned to it so that a network
management system (that is, Telnet) client can find it on the network.
The fields listed under the Current Switch IP Settings heading are those
currently being used by the switch module. The fields listed under the New
Switch IP Settings heading are those that will be used after the switch module
has been restarted. Toggle the Get IP From field using the space bar to choose
from Manual, BOOTP, or DCHP. This selects how the switch module will be
assigned an IP address on the next restart (or startup). The Get IP From
options are:
BOOTP
The switch module will send out a BOOTP broadcast request when it
is turned on. The BOOTP protocol allows IP addresses, network
masks, and default gateways to be assigned by a central BOOTP
44
IBM BladeCenter 4-Port Gb Ethernet Switch Module: Installation Guide
Default IP address
192.168.70.127
192.168.70.128
192.168.70.129
192.168.70.130
Advertisement
Table of Contents
