Table of Contents
Advertisement
Switch Information
When you select Switch Information from the Configuration menu, a window
similar to the following appears:
To set basic switch settings, enter a System Name in the first field, the physical
location of the switch in the System Location field, and the name of the
contact person responsible for the switch in the System Contact field. Then,
click Apply.
Clicking Apply makes your changes effective; however, if the I/O module is
restarted the changes will be lost. To enter the changes into NVRAM and make
them permanent, click Maintenance → Save Changes in the navigation pane.
The data fields on the Switch Information window are described as follows:
Device Type
A description of the switch type.
MAC Address
The Ethernet address for the device.
Boot PROM Version
Version number for the firmware startup code.
Firmware Version
Version number of the firmware code installed on the switch. This can
be updated by using the Update Firmware window in the Reset and
Update section of the Switch Information window.
26
IBM BladeCenter 4-Port Gb Ethernet Switch Module: Installation Guide
Advertisement
Table of Contents
