Front Direction Indicators; Rear Optical Unit - VESPA LX 125 150 Euro 3 User Manual

2. Turn on the headlight and check that the borderline of the projected light beam on
the screen is not lower than 9/10 of the distance from the ground to the centre of
vehicle headlamp and higher than 7/10;
3. If otherwise, adjust the right headlight with screw «A».
N.B.
THE ABOVE PROCEDURE COMPLIES WITH THE EUROPEAN STANDARDS RE-
GARDING MAXIMUM AND MINIMUM HEIGHT OF LIGHT BEAMS. REFER TO THE
STATUTORY REGULATIONS IN FORCE IN EVERY COUNTRY WHERE THE ve-
hicle IS USED.
03_23

Front direction indicators (03_24)

To replace the front turn indicator bulbs, remove the tail light taking out the retaining
screw "A", remove the bulb holder from its fitting; gently turn the bulb around 30º and
remove it. Follow the process in reverse order to refit.
03_24

Rear optical unit (03_25)

To access the rear taillight bulb it is necessary to remove the 2 fixing screws «D».
Gently push and turn the bulb about 30° and then remove it. To refit follow the same
steps but in reverse order.
N.B.
IF MISTING IS NOTICED ON THE INSIDE OF THE HEADLAMP GLASS, THIS
DOES NOT INDICATE A FAULT AND IS RELATED TO THE HUMIDITY AND/OR
TO LOW TEMPERATURES.
03_25
45