Table of Contents
Advertisement
3.
The info page displays the information and status of this projector.
4.
After pressing the button "Contact IT Help", the HELP DESK window will appear in
the upper right corner of the screen. You will be able to deliver messages to
RoomView™ software administrators/users who connect to the same local area
network.
For more information, visit
PJLink™, SNMP, AMX and Xpanel formats supported
This projector is PJLink™, SNMP V.1, AMX or Xpanel V1.10 compliant. For details,
please follow its user guide or website respectively to control and manage projectors.
Using the projector in standby mode
Some of the projector functions are available in standby mode (plugged in but not turned
on). To use these functions, be sure you have turned on the corresponding menus under
SYSTEM SETUP: Basic > Standby Settings, and the cable connections are correctly
made. For the connection methods, see the Connection chapter.
Power Saving
Less than 1W power consumption when Power Saving mode is turned on.
When Power Saving is On, the following settings are not available.
Active VGA Out
Selecting On outputs a VGA signal when the COMPUTER IN 1 and COMPUTER OUT
sockets are correctly connected to devices. The projector outputs the signal received only
from COMPUTER IN 1.
Active Audio Out
Selecting On outputs an audio signal when the AUDIO IN 1 and AUDIO OUT sockets are
correctly connected to devices. The projector outputs the audio signal received only from
AUDIO IN 1.
LAN Control
Select On when you wish to control the projector over a network when it is in standby
mode.
http://www.crestron.com
45
Press Exit to
go back to the
remote network
operation page.
& www.crestron.com/getroomview.
Advertisement
Table of Contents
