Table of Contents
Advertisement
Operation
Starting up the projector
1.
Plug the power cord into the projector and into a
wall socket. Turn on the wall socket switch
(where fitted). Check that the POWER
indicator light on the projector flashes blue
after power has been applied.
2.
Remove the lens cap. If it is closed, it could
become deformed due to the heat produced by
the projection lamp.
3.
Press
I
I
control to start the projector. The POWER
indicator light stays blue when the projector is
on.
(If necessary) Rotate the focus ring to adjust the
image clearness.
•
If the projector is still hot from previous activity, it
will run the cooling fan for approximately 90
seconds before energizing the lamp.
•
To maintain the lamp life, once you turn the
projector on, wait at least 5 minutes before turning
it off.
4.
If the projector is activated for the first time,
select your OSD language following the on-
screen instructions.
5.
Switch all of the connected equipment on.
POWER on the projector or remote
ZOOM
22
M EN U
EXIT
M E N U
EXIT
Advertisement
Table of Contents
