Table of Contents
Advertisement
3.
ViewMatch mode: Switches between high brightness performance and accurate color
performance.
4.
Movie mode: Is suitable for enjoying dark movies or DVD movies best viewed in a
blackened (little light) home cinema or lounge room environment.
5.
Dynamic Movie mode: Is suitable for enjoying dark movies or DVD movies best
viewed in a blackened (little light) home cinema or lounge room environment. In
addition, the projector will optimize the image quality using the dynamic Movie
function in accordance with the projected contents.
It takes the projector several minutes after it is turned on or resumed to initiate dynamic Movie
function, so that the image contrast can be enhanced.
6.
User 1/User 2 mode: Recalls the settings customized based on the current available
picture modes. See
Setting the User 1/User 2 mode
There are two user-definable modes if the current available picture modes are not suitable
for your need. You can use one of the picture modes (except the User 1/User 2) as a starting
point and customize the settings.
1.
Press MENU/EXIT on the projector or Menu on the remote control to open the On-
Screen Display (OSD) menu.
2.
Go to the PICTURE > Color Mode menu.
3.
Press
/
to select User 1 or User 2.
4.
Press
to highlight Reference Mode.
This function is only available when User 1 or User 2 mode is selected up in the Color Mode
sub-menu item.
5.
Press
/
to select a picture mode that is closest to your need.
6.
Press
to select a sub-menu item to be changed and adjust the value with
See
Fine-tuning the image quality in user modes
7.
When all settings have been done, highlight Save Settings and press MODE/ENTER
on the projector or Enter on the remote control to store the settings.
8.
The confirmation message 'Setting Saved' is displayed.
Using Screen Color
In the situation where you are projecting onto a colored surface such as a painted wall which
may not be white, the Screen Color feature can help correct the projected picture's colors to
prevent possible color difference between the source and projected pictures.
To use this function, go to the DISPLAY > Screen Color menu and press
color which is closest to the color of the projection surface. There are several precalibrated
colors to choose from: Whiteboard, Greenboard, and Blackboard.
This function is only available when a PC type input signal is selected.
Fine-tuning the image quality in user modes
According to the detected signal type, there are some user-definable functions available
when User 1 or User 2 mode is selected. You can make adjustments to these functions
based on your needs.
"Setting the User 1/User 2 mode" on page 34
34
for details.
below for details.
/
/
.
to select a
Advertisement
Table of Contents
