Speaker Layout; Connecting A Tv - JVC TH-C6 Instructions Manual

Connections

Speaker layout

Center speaker
Front left
speaker
Surround left
speaker
• Place the satellite speakers on a flat and level surface.
• The front and center speakers are magnetically shielded to avoid color
distortions on TVs. However, if not installed properly, they may
cause color distortions. So, pay attention to the following when
installing the speakers.
– When placing the speakers near a TV set, turn off the TV's main
power switch or unplug it before installing the speakers. Then wait
at least 30 minutes before turning on the TV's main power switch
again.
Some TVs may still be affected even though you have followed the
above. If this happens, move the speakers away from the TV.
• The surround speakers are not magnetically shielded.
If it is located nearby the TV or monitor, it will probably cause
color distortion on the screen. To avoid this, do not place the
speaker nearby the TV or monitor.
• Be sure to place the powered subwoofer to the TV's right. If you place
the powered subwoofer to the TV's left, keep sufficient distance
between them to prevent the TV screen from appearing mottled.
Do not connect the power cord until all other connections have been made.
Front right
speaker
Powered
subwoofer
Surround right
speaker

Connecting a TV

• You can get better picture quality in the order — Component
video > S-video > Composite video.
• Distortion of picture may occur when connecting to the TV via a
VCR, or to a TV with a built-in VCR.
• You need to set "MONITOR TYPE" in the PICTURE menu
correctly according to the aspect ratio of your TV. (
To connect a TV equipped with the component video
input jacks
Center unit
Component video cord (not supplied)
NOTE
• If your TV supports progressive video input, you can enjoy a high
quality picture by setting the progressive scan mode to active.
( pg. 18)
• If the component video input jacks of your TV are of the BNC type,
use a plug adapter (not supplied) to convert the pin plugs to BNC
plugs.
• The component video signals can be output only when you select
"DVD" as the source to play. (
To connect a TV equipped with the composite or S-
video jacks
Center unit
Composite video cord
(supplied)
or
S-video cord
(not supplied)
Align the marks.
To S-video input
pg. 37)
TV
To component
video input
pg. 17)
To composite
video input
TV
12