Connections; Connecting The Fm And Am Antennas - JVC TH-C6 Instructions Manual

Connections

Connecting the FM and
AM antennas
AM loop antenna
Setting up supplied AM loop antenna
If the antenna cord is covered with the insulation
coat, twist and pull the insulation coat off and
remove.
Connecting AM loop antenna
1
Center unit
2
3
• Turn the loop antenna until you have the best reception during
AM broadcast program reception.
NOTE
• Make sure the antenna conductors do not touch any other terminals,
connecting cords and power cords. This could cause poor reception.
7
Do not connect the power cord until all other connections have been made.
Antenna cord
If reception is poor
AM loop antenna
Outdoor single vinyl-covered wire antenna
(not supplied)
FM antenna
Center unit
Extend the supplied FM antenna
horizontally.
If reception is poor
Center unit
Standard type (75
coaxial) connector
NOTE
• We recommend that you use coaxial cable for the FM antenna as it is
well-shielded against interference.
Center unit
FM antenna (supplied)
Outdoor FM antenna
(not supplied)
Outdoor FM antenna cord
(not supplied)