Network Everywhere NR041 User Manual page 15

PPPoE
If your DSL provider says that
you are connecting through
PPPoE or if you normally enter
a user name and password to
access the Internet, perform
these steps:
A. Select PPPoE as the WAN
Connection Type.
B. Enter the User Name.
C. Enter the Password.
D. Click the Apply button and then the Continue button to save the settings., or
click the Cancel button to clear the settings and start over.
E. When you are finished, click the Status tab, and then click the Connect
button to start the connection. Proceed to step 5.
22
Network Everywhere Series
™
Figure 5-5
Cable/DSL 4-Port Router
5. If you haven't already done so, click the Apply button and then the
Continue button to save your Setup settings. Close the web browser.
6. Reset the power on your cable or DSL modem.
7. Restart your computers so that they can obtain the Router's new settings.
If you need advanced setting information, please refer to "Chapter 6: The
Router's Web-based Utility" or the Network Everywhere support website at
www.NetworkEverywhere.com.
Test the setup by opening
your web browser from any
computer and entering
http://www.linksys.com/registration.
Congratulations! You've successfully configured the Router.
If you are unable to reach our website, you may want to review what you
did in this section or refer to "Appendix A: Troubleshooting."
Proceed to "Chapter 6: The Router's Web-based Utility" for more details
and advanced settings information.
Figure 5-6
23