Controls And Features - Troy-Bilt Series 200 World Rear Wheel Tiller Operator's Manual

Controls and Features

Fuel Cap
Starter Handle
† If Equipped
Choke
(If Equipped)
The choke control is located on the left side of the handle or on
the engine below the engine switch and when activated, closes
the choke plate on the carburetor and aids in starting the engine.
Pull the choke control to activate the choke on the engine. Use of
the choke may not be necessary if the engine is warm or the air
temperature is high.
Primer
(If Equipped)
The primer is located on the left side of the
engine, on the front of the air cleaner. Pressing
the primer forces fuel directly into the engine's
carburetor to aid in starting the engine.
Engine Switch
(If Equipped)
The engine switch is located on the engine. Turn the switch "On"
when starting the engine and turn it to "Off" when you want to
shut it down.
Starter Handle
Pull the starter handle to start the engine.
8
Engine
Switch†
Choke†
Oil Fill Cap
Oil Drain
Valve†
Spark Plug
Figure 4-1
Fuel Shut-Off Valve
The fuel shut off valve is located on the engine to the right of the
choke. Be sure the valve is on before starting the engine. Turn the
valve off when towing or transporting equipment.
Oil Drain
Removing the oil drain plug will drain the oil from the engine.
The engine is equipped with a side drain, and on select units, you
may also access a bottom drain.
Oil Fill Cap
Remove the oil fill cap to check the oil level and add oil.
Fuel Cap
Remove the fuel cap to add fuel.
NOTE: Some engines may not have the fuel cap installed for
shipping purposes. To install, remove and discard the fuel tank
dust cap labeled "Discard". Remove the bubble wrap packaging
from around the fuel cap and tighten securely.
Air Cleaner
Primer†
(If Equipped)
4