Troy-Bilt OEM-290-264 Installation And Use Instructions

TILLER/EDGER
INSTALLATION AND USE INSTRUCTIONS
Introduction
Thank you for ordering this aerator attachment for your
tiller/edger. We know that it will perform to your satisfac-
tion if installed and used properly as described in the fol-
lowing instructions.
The shipping carton contains four aerator tines (see Figure
1). If any tines are missing or damaged, be sure to contact
your authorized tiller/edger dealer or the factory.
To help ensure the proper installation and safe operation of
this attachment, read and carefully follow these instruc-
tions. If you have any questions or concerns, please con-
tact your authorized tiller/edger dealer or the factory.
SINGLE TINE ORDERING INFORMATION: In case of wear
or damage, a single aerator tine can be ordered by request-
ing Part Number 1915054.
Figure 1: Four aerator tines are included in the kit.
Tools/Supplies Needed
• No tools are needed.
• Fine-grade sandpaper (to remove rust from tine shaft).
• General purpose oil (to lubricate tine shafts).
®

Aerator Attachment

OEM-290-264 / 290-264-081
Figure 2: The aerator tines are easily mounted on the tine shaft.
The aerator tine attachment hardware (hairpin cotters, threaded
knobs or ring lock pins) will vary depending upon which tiller
model you have.
Safety
Before installing or using this attachment, carefully review
the "Safety Rules" and "Operation" instructions in your
Tiller/Edger Owner's Manual. Doing so will refresh your
memory concerning safe operating practices that must be
followed at all times.
TO AVOID INJURY:
• Read the owner's manual.
• Know the location and function of all controls.
• Keep all safety devices and shields in place.
• Never allow children or uninstructed adults to operate
the machine.
• Shut off engine and disconnect spark plug wire before
unclogging tines or making repairs.
• Keep bystanders away from machine.
• Keep away from rotating parts.
CAUTION