Page 1
™ switch to voice your fuzz tone the way you want it. You can start using your Tweak Fuzz right away and you’ll immediately notice that the soft clipping and natural compression make it extremely player-friendly. However, you might want to first read through these instructions to gain valuable infor-...
Page 2
– yes, the Tweak Fuzz also sounds amazing with a bass. Gain – This knob controls the amount of fuzz, also called square wave clip- ping distortion.
Page 3
“-“ terminals (see Figure 1 for proper battery orientation). e Reassemble the chassis and replace the screws. When storing the Tweak Fuzz, or when it is not in use, make sure no cable or plug is inserted into the “Input” jack, as this will shorten battery life. As an alternative to a battery, you can use a regulated DC power supply (“wall...
Page 4
The ¼” mono instrument cable that leaves your guitar’s jack or the effect immediately before the Tweak Fuzz, plugs into the Tweak Fuzz’ jack marked “Input. ” The cable that exits from the “Output” jack on the Tweak Fuzz goes to the next effect in the signal chain, or to the amplifier.
Page 5
For more ideas on how to use this great stomp box for guitar and bass, check out the video clips on seymourduncan.com featuring Blues. Because of the Tweak Fuzz’ incredible amount of gain and distortion, be aware that extreme settings can result in uncontrollable feedback. And, as always, musicians and audience members are best advised to use ear protection when exposed to loud volume.
Need help?
Do you have a question about the Tweak Fuzz and is the answer not in the manual?
Questions and answers