JVC HR-XV38SAG Instructions Manual page 55

8 AUTO SP]LP TIMER — ON / OFF
When this function is set to "ON," the unit automatically
switches to LP mode to allow complete recording if there is not
enough tape to record the entire programme while timer-
recording in SP mode.
For Example:
Recording a programme of 210 minutes in length onto a 180-
minute tape
Approximately 150 minutes
SP mode
Total 210 minutes
Make sure you set this function to "ON," before the timer-
recording starts.
NOTES:
● If you have programmed the unit to timer-record 2 or more
programmes, the second programme and those thereafter may
not fit on the tape if you set "AUTO SP]LP TIMER" to "ON."
In this case, make sure the mode is not engaged, then set the
tape speed manually during timer programming.
● In order to ensure that the recording fits on the tape, this
feature may leave a slight non-recorded section at the end of
the tape.
● There may be some noise and sound disturbance at the point
on the tape where the unit switches from SP to LP mode.
● The Auto SP
LP Timer feature is not available during ITR
]
(Instant Timer Recording), and the feature will not work
properly with any tapes longer than E-180, or with some tapes
of shorter lengths.
8 VIDEO STABILIZER — ON / OFF
When this function is set to "ON," you can automatically correct
vertical vibration in the picture when playing back unstable
recordings made on another recorder.
NOTES:
● When you finish viewing a tape, be sure to set this function to
"OFF."
● Regardless of the setting, this function has no effect during
recording and during special effects playback.
● The on-screen display may jitter vertically when this function
is set to "ON."
● To watch recordings with close-caption, set this function to
"OFF."
8 AUTO POWER OFF — 3H / OFF
When this function is set to "3H," the unit is turned off
automatically if no operation is done within 3 hours. "AUTO
POWER OFF IN 3 MIN" appears on the screen 3 minutes before
the unit is turned off.
Approximately 60 minutes
LP mode
55
EN