Table of Contents
Advertisement
46
EN
Edit To Or From Another
Video Recorder
You can use your unit as the source player or as the
recording deck.
A When using your unit as the source player:
Player
TV receiver
Audio/video
cable
VCR channel
or AV mode
Recorder
B When using your unit as the recording deck:
TV receiver
Recorder
F-1 VIDEO/AUDIO
Audio/video cable
VCR channel
or AV mode
Player
Recorder
TV receiver
Audio/video
cable
VCR channel
or AV mode
Player
Your unit
AUDIO/VIDEO
OUTPUT
Audio/video
cable
Another recorder
Your unit
Audio/video
cable
Another recorder
Your unit
INPUT (L-1)
Audio/video
cable
Another recorder
EDITING (VHS DECK) (cont.)
Slide the TV/VCR/DVD switch on the remote control
to the right.
A
Make connections.
A When using your unit as the source player:
— connect its AUDIO/VIDEO OUTPUT connectors to
the recording deck.
B When using your unit as the recording deck:
— connect its L-1INPUT connector to the source
player.
B
Select the VHS deck.
On the unit
Press VCR/DVD repeatedly so that the VCR indicator
lights up.
On the remote control
Press VCR so that the VCR indicator lights up.
C
Set the input mode of recording deck.
With this unit, press AUX (number key "0") and/or PR to
select correct external input on the recording deck.
On this unit (when using this unit as the recording deck);
Select "L-1"— when connecting the other recorder to the
AV input connectors on the rear panel.
Select "F-1"— when connecting the other recorder to the
AV input connectors on the front panel.
● When using another recorder as the recording deck, refer to its
instruction manual.
D
Set the edit mode.
See "PICTURE CONTROL" on page 54.
E
Engage the Record Pause mode of the
recording deck.
Locate the point where you start recording, then engage
the Record Pause mode.
F
Start the source player.
Engage the Play mode of the source player.
G
Start the recording deck.
Engage the Record mode of the recording deck.
NOTES:
● All necessary cables can be obtained from your dealer.
● When you select "EDIT" to dub tapes in step D, be sure to
select "AUTO" (or "NORM" when "B.E.S.T." is set to "OFF")
after you finish dubbing the tapes.
● When you use this unit as the source player for editing, be sure
to set "O.S.D." to "OFF" before starting. (
pg. 54)
Advertisement
Table of Contents
