Table of Contents
Advertisement
The image is out of focus.
The focus can be adjusted by following the
procedure given below.
1.Set the pan and tilt positions to 0˚,0˚.
2.Remove the lens cover.
3.Loosen the screw locking the lens
block.
Note:For your safety, turn off the power
before loosening the screw.
4.Start up the VN-C2U controller so that
the VN-C2U image can be viewed.
5.Rotate the lens block slowly until the
image is in focus.
6.Securely tighten the lock screw.
7.Close the lens cover (check to make
sure that the notches on the lens cov-
er and case are aligned).
Lens block
Mount so that the notches
are aligned
Lens cover
Lock screw
22
Advertisement
Table of Contents
