JVC V.Networks VN-C2U Instructions Manual page 13

3-3 VN-C2U IP address setup
The V.NETWORKS setup tool is located in the \JVC\setup folder of the CD-ROM.
Execute \JVC\setup\vsetup.exe (execute directly from the CD-ROM).
The Camera ID is equivalent to the ID
code of the VN-C2U main unit. Input
using alphanumerics. This setting does
not directly concern users.
Normally this ID is set by numbering up.
Set appropriate values for the sub-net
mask during the setting. If unknown,
contact your network management.
For an explanation of the password button, see the following page.
Input the IP address of VN-C2U being
set.
Factory set IP address is 192.168. 1. 2.
Input the IP address assigned or
authorized by the network management.
(The illustration shows an example
using 172.16. 1. 50.)
Depending on the installation condition,
select either Normal installation (JVC
mark on VN-C2U is upright) or Inverted
installation (if uncertain due to a special
installation, select Normal)
Setting to reduce flickering under
fluorescent lighting.
Specify 50Hz or 60Hz, depending on
the power supply frequency of the
installed location.
8