Dubbing To A Video Unit Equipped With A Dv Connector - JVC GR-DVL140 Instructions Manual

To DV OUT
Core filter
DV cable
(optional)
Core filter
To DV IN
Video unit equipped with
DV input connector
Dubbing To A Video Unit Equipped With A
DV Connector (Digital Dubbing)
It is also possible to copy recorded scenes from the
camcorder onto another video unit equipped with a DV
connector. Since a digital signal is sent, there is little if any
image or sound deterioration.
1
Lock Button
2
Power Switch
3
4
NOTES:
Make sure all units are turned off. Connect the
camcorder to a video unit equipped with a DV input
connector using a DV cable as shown in the
illustration.
Set the camcorder's Power Switch to "
pressing down the Lock Button located on the switch,
turn on the video unit's power, and insert the
appropriate cassettes in the camcorder and the video
unit.
Press 4 to play back the source tape.
While watching the playback on the monitor, engage
the DV connector-equipped video unit's record mode
from the spot on the source tape you want to begin
recording.
It is recommended to use the AC Adapter as the power
supply instead of the battery pack (
If a blank portion or disturbed image is played back on
the player during dubbing, the dubbing may stop so that
an unusual image is not dubbed.
Even though the DV cable is connected correctly,
sometimes the image may not appear in step 4. If this
occurs, turn off the power and make connections again.
If "Playback Zoom" (
attempted during playback, only the original playback
image recorded on the tape is output from the DV OUT
connector.
When using a DV cable, be sure to use the optional JVC
VC-VDV204U DV cable.
EN
" while
pg. 9).
pg. 44) or "Snapshot" is
41