Lincoln Electric LN-25 Service Manual page 55

F-18
FIGURE F.9 Ð CONT ACTOR LEAD IN-LINE CONNECTORS.
TEST PROCEDURE
1. Open the case door . Remove the wire
reel by removing the retaining collar
See Figure F .1.
2. Remove the three screws holding the
control box cover in place and remove
the control box cover . See Figure F .1.
TROUBLESHOOTING AND REPAIR
CONTACTOR TEST (continued)
IN-LINE
CONNECTORS
3. Separate the two in-line connectors
located behind the reel stand
assembly . See Figure F .9. For codes
.
9812 and below , remove the two
contactor
contactor PC board. See Figure F .10.
LN-25
F-18
coil leads from the