Network; Menu Position; Start Up Logo; Start Up Chime - Hitachi CP-WU13K User Manual

Network

To control the projector via network, after connecting the network cables for a PC and the projector,
you can use this OSD function to view the relevant network information (such as IP Address, Subnet
0DVN *DWHZD\ DQG '+&3 RI WKH SURMHFWRU 3OHDVH FRQ¿JXUH WKH 3& WR EH FRQQHFWHG WR WKH SURMHFWRU
with a proper IP address with the same subnet mask, gateway as the projector. The default IP address
of the projector is 192.168.0.100. The network settings of the projector can only be changed through
the web-page control or projector Toolset application.
To control the projector via network, please connect to the projector via a web browser with the IP
address shown on the OSD menu CONTROL -> Network.

Menu Position

You can use this function to designate which area on the image the OSD Menu will appear.
$V \RX FDQ VHH IURP WKH GLDJUDP EHORZ WKHUH DUH ¿YH SRVLWLRQV ZKHUH \RX FDQ FKRRVH WR KDYH WKH
OSD Menu displayed. The default setting is "Center".

Start Up Logo

You can use this function to have the projector display the HITACHI logo in the start up screen. Set
On to display the HITACHI logo during start up and

Start Up Chime

Set it to On to have the projector play a sound effect during start up; when it is set to off, the projector
will not play any sound effect to indicate start up.
Button 1~5
Use this function to designate the image source for each corresponding button.
For example, if you have assigned Button 1 as HDMI1 and Button 2 as YUV1,
1
when you press on the remote control, the projector will show the image from HDMI1.
1
when you press on the remote control, the projector will switch to the image from YUV1.
You can choose from eight different input sources on the projector, namely: HDMI1, HDMI2
RGB D-15, YUV1, RGBHV/YUV2, SDI/HDSDI/3G and STEREO DVI
Top Left
Center
Bottom Left
OSD Menu description
Top Right
Bottom Right
Off to display a blank image.
51