Operation - DeWalt DWE315-XE Instruction Manual

NOTE: The dust extraction adaptor is available on selected model only.
Q
FIG. 13
P
O

OPERATION

WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect tool from power source before making any adjustments or removing/
installing attachments or accessories. An accidental start-up can cause injury.
Proper Hand Position (Fig. 14)
WARNING: To reduce the risk of serious personal injury, ALWAYS use proper hand
position as shown in Figure 14.
WARNING: To reduce the risk of serious personal injury, ALWAYS hold securely in
anticipation of a sudden reaction.
Using the Dust Extraction Adaptor with the
Sanding Platen (Fig. 14)
1. Attach the dust extraction adaptor (Q). Refer to
Attaching the Dust Extraction Adaptor.
2. Attach the sanding platen (I) as described under
Installing/Removing Accessories.
3. Attach sanding sheet as described under Installing/
Removing Sanding Sheets.
Using the Dust Extraction Adaptor with
Plunge Cutting Accessory (Fig. 15)
1. Attach the dust extraction adaptor. Refer to Attaching
M
2. Push dust extraction arm (R) into the lower aperture
3. Attach plunge cutting bit as described under
4. Adjust the dust extraction arm (R) for best results.
Variable Speed Trigger (Fig. 16)
E
WARNING: Ensure switch is fully OFF before plugging
in the power cord.
1. Plug in power cord.
2. To turn the tool ON, hold it as shown in
FIG. 14
Q
3. To turn the tool OFF, release the variable speed switch (A).
Lock-on Button (Fig. 17)
For more comfort in extended use applications, the
lock-on button (D) can lock the trigger switch (A) in
the depressed position.
I
7
the Dust Extraction Adaptor.
of the dust extraction adaptor (Q).
Installing/Removing Accessories.
Figure 14 and press the variable speed
trigger (A).
NOTE: The further the trigger switch
is depressed the faster the tool will
operate. If in doubt about the proper
speed for your operation, test the
performance at low speed and
gradually increase until a comfortable
speed is found.
FIG. 15
Q
R
FIG. 16
A
FIG. 17
D
A