Advertisement
CAUTION
:
*The fast charger Model DC1201
is
specifically designed to charge only Makita battery
cartridges. Never use it for other purposes or for other manufacturer's batteries.
0
When you charge a new battery cartridge or a battery cartridge which has not been used
for a long period of time,
it
may not accept a full charge. This
is a
normal condition and
does not indicate
a
problem. You can recharge the battery cartridge fully after discharg-
ing
it
completely and recharging a couple of times.
0
I f you charge a battery cartridge from a just-operated tool or a battery cartridge which
has been left in a location exposed to direct sunlight or heat for a long time, the charg-
ing light may flash in red color. If this occurs, wait for a while. Charging will begin after
the battery cartridge cools.
0
I f the charging light flashes alternately in green and red color and
a
tone sounds "beep,
beep, beep,
. .
. ' I
for about 20 seconds, a problem exists and charging i s not possible.
The terminals on the charger or battery cartridge are clogged with dust or the battery
cartridge i s worn out or damaged.
0
I f you wish
to
charge two battery cartridges, allow 15 minutes between chargings
on
the
fast charger.
Installing
or
removing
the
drill bit
or
driver bit
CAUTION :
Always be sure that the tool
is
switched off and the battery cartridge i s removed before
installing or removing the bit.
To install the bit, push the sleeve up to-
ward the "FREE" side and turn the sleeve
counterclockwise while holding the ring
with your other hand as illustrated a t right.
Place the bit in the chuck as far as it will
go. Hold the ring firmly and turn the sleeve
clockwise to tighten the chuck. Then push
the sleeve down toward the "LOCK" side.
To remove the bit, push the sleeve up toward the "FREE" side and turn the sleeve
counterclockwise while holding the ring with your other hand.
7
Advertisement
